Bambu Lab - A1 mini - 3D Effect Surface Plate -

The A1 mini Effect Surface Plates allow you to easily and simply apply one of the effects shown below to the underside of a print.
The plate already has an effect film applied to both sides, so you can start printing straight away.

Notes:

1. Please set the plate type to Smooth PEI/High Temp Plate and carefully follow the recommended settings for the heated bed when using the Bambu 3D Effect Plate.
2. The 3D effect patterns require a clean surface to remain visible. Grease can cause the patterns to disappear. It is important to keep the surface clean. We recommend using hot water and detergent and avoiding contact with the surface.
3. Due to reflections, LIDAR calibration will not work as expected when using effect sheets. We recommend skipping the LIDAR calibration sequence or calibrating with a standard plate.
4. The 3D effect replacement sheets are considered consumables. To extend the lifespan of the transfer textures, try to place your print objects in different areas of the sheet.
5. Do not apply adhesives to the sheet surface.
6. When using a scraper to remove prints, take care not to damage the sheet surface.